If your having to press the reset every time to get the ice to drop it could be the ice maker sensor.
Samsung french door refrigeration not making ice or water.
32 hours later no ice has been made.
Approximately 10 ours later there s still no ice made.
Grasp the latch release on the right side of the bucket squeeze to release and pull the bucket out.
Samsung says the water line within the freezer door can freeze.
The lower has stopped making ice.
Have samsung french door refrigerator.
Could also be the tempature isn t cold enough.
It was plugged in and set the freezer to 0 degrees.
How to reset ice maker for samsung refrigerator french door.
Make sure that the water valve on the refrigerator water supply line is completely open.
Save hundreds of so do this before you call for service.
It tells you to disconnect the orange water line and blow air through it.
Samsung ice maker not working.
But if you ve noticed ice cream is softer or the milk taste bad than your problem isn t in the ice maker.
Samsung states to check the orange water line at the front bottom of the refrigerator and see if the water line is frozen.
Currently samsung does not have a recall in place for any of its refrigerator models when it comes to the ice maker issue.
If no air comes out from the end it tells you to replace the freezer door.
Last night i set it 1 degrees and hit the reset button.
The upper ice maker and water work fine.
Open the left refrigerator door and locate the ice bucket in the upper left corner.
I bought my refrigerator 2 days ago.
If ice production doesn t commence after your refrigerator has been installed for 24 hours clear the dispenser of air by holding down the dispenser button for 60 seconds or until it dispenses.
You can find the water valve where the refrigerator water supply line taps into your house water line.
Freezer temperature must be 0 c for the ice maker to work properly.
However there is a facebook group of more than 6 400 members calling for.
If everything is cooling fine i d replace the ice maker.
The motor runs when the test button is pressed but doesn t appear to read more.